We Checkline Europe Ltd would like to use cookies and similar technologies in order to optimize your shopping experience and this requires your consent. By clicking on the "Accept cookies" button you agree to our use of cookies and similar technologies. If you do not agree, you can refuse the use or customize settings for the respective cookies by clicking on the button "Cookie Settings".You also have the possibility to specify that only certain cookies, which we use on our website should be activated. This banner will be displayed until you have selected your cookie preferences. If you decide against the use of cookies, we will not use cookies nor similar technologies, except those that are essential for the proper functioning of the website. Click here for our privacy policy
Contact Us
Checkline Europe
Chat function is not available since you have not allowed us to use tracking cookies.

TI-MAX Bolt Tension Meter

Made in the USAThe TI-MAX, Ultrasonic Bolt Tension Monitor, defines the state of the art in the measurement of the actual elongation produced by tightening a threaded fastener.

The TI-MAX can measure the elongation very accurately in fasteners of virtually any material from 1/2 inch to 4 feet in length. The measurement is achieved by determining the change in the transit time, of an ultrasonic shock wave along the length of the fastener as the fastener is tightened by any method.

The on-board microcomputer automatically interprets this time measurement to display the time(nanoseconds), elongation, load, stress, or %strain from stretching a fastener.

  • Display Options - RF, Rectified, Large Digits with Limits Bar.
  • The first cost effective ultrasonic solution available on the market.
  • Visually compare the unloaded to the loaded waveform.
  • Measurement quanities - Time (nanoseconds), Elongation, Load, Stress, and %Strain.
  • Effectively monitor your bolts during periodic shutdowns over the service life of the fastener.
  • Built-in Linear regression or vector for optimizing load measurements.
  • Display Resolution - 1/8" VGA 240 x 160 pixels.
  • Stores 8000 readings and waveforms in multiple groups.
  • The Auto Set feature automatically optimizes detection and adjusts display.
  • Hi/Lo alarm tolerance limits work in conjunction with the data port and external pump shut-off device.


CF-AN Coupling Fluid

  • Used to create an ultrasonic coupling between the probe and material to be measured
  • Available in different quantities - 125ml / 250ml / 500ml / 1ltr / 5ltr / 25ltr

More details

CF-AN Coupling Fluid 126455

TICC-MVX Protective Holder for Ultrasonic Gauges

  • Constructed from heavy duty Cordura Nylon
  • Built-in belt loop
  • Includes wrist & shoulder straps

More details

TICC-MVX Protective Holder for Ultrasonic Gauges 126247

Complete Kit
The TI-MAX is supplied as a kit including: - Gauge
- 2 AA batteries
- 4 oz. Bottle of Couplant
- RS232 Transfer Cable
- Lemo to Microdot Transducer Cable

- Windows Utility Software
- Carrying Case
- Operation Manual

Measuring probes and cables are not included.


Measuring Range From 1” to 48” (25.4mm to 122cm) bolts
Time Nanoseconds
Elongation Change in length (inches/millimeters)
Load Force load applied (pounds kIP or kN Killonewtons)
Stress Force for unit area stress applied (pounds kPSI or megapascals MPa)
Strain % percentage strain applied (inches per inch or millimeters per millimeter)
Resolution +/- .00001 inches (0.0001 mm)
Velocity Range .0492 to .3936 in/ms 1250 to 9999 meters/sec
Calibration Fixed, Single, and Two point zero calibration options.
Units English & Metric / Fahrenheit & Centigrade
Measuring Modes Pulse-Echo (standard) Pulse-Echo w/Gate (fine adjust)
Pulser Square wave pulser with adjustable pulse width (spike, thin, wide)
Receiver Manual or Auto Set gain control with 40dB range
Timing 10 bit 250 MHz digitizer
Display Modes A-Scan - Rectified +/- (half wave view), or RF (full waveform view)
Alarm Limits Set hi and lo tolerances with audible beeper, viewable scan bar, and visual LEDs
Data Logger (Internal) Total of 8,000 readings, multiple bolt groups. Stores both waveform views, nanoseconds, elongation, load, stress, and strain for each reading
Memory 16 megabit non-volatile ram
Transducer Single Element (1 to 10 MHz & 1/8” to 1” diameters)
Transducer Cable Lenght 10 foot (custom lengths available, inquire)
Temperature Probe for automatic temperature compensation
Setup Memory 64 custom user defined setups. Factory setups can also be edited by the user
Gate Gate used to fine adjust where the detection point occurs
Auto Set Locates the detection signal, optimizes the gain setting, and adjusts the overall display to show the waveform and detection point automatically
Field Calibration Vector & linear regression. Includes Factory calibration traceable to national standards
Power Three 1.5V alkaline or 1.2V NiCad AA cells.
Dimensions Width (2.5in/63.5 mm) Height (6.5 in/165 mm) Depth (1.24 in/31.5 mm)
Weight 13.5 ounces (with batteries)
Operating Temperature 14 to 140F (-10C to 60C)

Buy Now

Product name
TI-MINIMAX-C - TI-MiniMax-C Bolt Tension Gauge with temperature connector
£ 2.937,00 
TI-MINIMAX - TI-MiniMax without temperature connector (Manual Temperature setting)
£ 2.937,00 

Product name
CF-AN-250ml Coupling Fluid 250ml Bottle
£ 16,00 
TICC-MVX Protective Pouch for TI-Series Large
£ 85,00 
BATT-RC4AA-WC 4-pack 2300mAh AA Ni-MH Rechargeable Batteries & Charger Kit
£ 35,00 
X-000-0010 - One each of 3" & 6" Steel Cal Bars for Probe zero purposes
£ 570,00 
N-110-0020 Transducer Cable, Lemo to microdot
£ 83,00 
T-700-2405 1/8" 5MHz TI-MAX Probe Magnetic
£ 807,00 
T-700-4405 1/8" 10MHz TI-MAX Probe Magnetic
£ 807,00 
T-702-1405 1/4" 2.25MHz TI-MAX Probe Magnetic
£ 829,00 
T-702-2405 1/4" 5 MHz TI-MAX Probe Magnetic
£ 829,00 
T-702-4405 1/4" 10MHz TI-MAX Probe Magnetic
£ 829,00 
T-703-1405 - 3/8in, 2.25 Mhz TI-MAX Probe Magnetic
£ 839,00 
T-703-2405 3/8" 5MHz TI-MAX Probe Magnetic
£ 839,00 
T-704-1405 1/2" 2.25MHz TI-MAX Probe Magnetic (for Steel Bolts up to 1.3 Meter
£ 850,00 
T-704-2405 1/2" 5MHz TI-MAX Probe Magnetic for Steel Bolts in Petro/Power Plants
£ 850,00 
T-706-1405 3/4" 2.25 MHz TI-MAX Probe Magnetic
£ 910,00 
T-706-2405 3/4" 5 MHz TI-MAX Probe Magnetic
£ 910,00 
T-602-1405 1/4" 2.25 MHz TI-MAX Probe Non-Magnetic
£ 334,00 
FCR2525 Flaw Probe 2.25 mHz Probe 1/4"
£ 329,00 
A-156-8001 Magnetic Temperature Sensor for temp compensation
£ 569,00 
All mentioned prices are excluding VAT & excluding shipment costs.
Availability : Available , preorder 1-2 weeks , special order, request